Wall Mount Installation – Kit 46-00913
1. Drill two #39 pilot holes in the mounting surface. The pilot holes should be
centered vertically 44 mm apart.
2. Position the wall mount over the pilot holes with the arrow pointing up.
3. Secure the wall mount to the wall with the two #7 wood screws () provided
in the kit.
Figure 8
4. Slide the unit's base under the upper corner tabs on the wall mount.
5. Slide the remainder of the base in and down behind the lower corner tabs.
Figure 9
© 2007-2013 Honeywell International Inc. All rights reserved.
00-05250 Rev E
4/13
- 4 -
