INSTALL INSTRUCTIONS C-TCB-34
TELESCOPING COMPUTER BASE
2004-2008 GMC / CHEVROLET CANYON/COLORADO
TOOLS REQUIRED:
Ratcheting Wrench
Standard & Metric Socket Set
Power Drill
Drill Bit Set
HARDWARE:
QTY DESCRIPTION
PART #
2
1
1
2
1
1
1
¼” x 1” Hex head lag bolts
5/16-18 Nylock Nut
5/16-18 x 1” Hex head bolt
5/16” Flat Washers
Pole Support Assembly
Lateral Cross Brace
Inner Telescoping Pole Assembly
GSM33060
GSM30017
GSM33012
GSM31006
CM97031-34W
110-000034
CM93072-1
Always!
ꢀ
ꢀ
Read all instructions before installing any Havis-Shields Equipment Corp products.
Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles computer a false
reading, causing a warning light on the instrument cluster. This requires the vehicles’ computer to be reset with
a vehicle diagnostics tool.
ꢀ
ꢀ
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use only hardware provided with install kit.
ꢀ For product support, visit the Install Instructions Section of our website at
ask for technical support.
SUB ASSEMBLY:
1. Confirm receipt of all parts.
2. Remove passenger side, front seat bolts.
Inner Telescoping
Pole Assembly
INSTALLATION:
1. Mount C-TCB-34:
Lateral Support
• Press back on seat and slide Pole support
assembly between seat bracket and floor of
vehicle.
Brace
• Line up slots in Pole support assembly with
bolt holes on floor.
• Reattach bolts removed in sub-assembly.
Hand-tighten only.
Pole Support
Assembly
• Attach Lateral cross brace to tab on side of
TCB using 5/16-18 x 1” bolts, washers and
Nylock nut. Tighten.
• Pre-drill 5/32” holes into floor of vehicle where support brace and floor meet.
• Attach to vehicle using (2) ¼” x 1” Hex head lag bolts.
• Completely tighten seat bolts and insert Telescoping Pole.
C-TCB-34_INST_9-07
|