Haier Washer HLP455E User Manual

Twin-tub Washing Machine  
User's manual  
Model : HLP455E  
Please read this manual  
carefully before using.  
Retain it for future reference.  
The machine is for cold water  
connection only.  
 
Names of the parts  
Outer cover of the spin tub  
Wash timer Water-filling entrance  
Wash selector  
Wash tub cover  
Spin timer  
Wash tub  
Inner cover of  
the spin tub  
Control panel  
Spin tub  
Power cord  
Cabinet  
Hook of fixing  
the drain hose  
Back cover  
Drain hose  
Base frame  
Pulsator  
Bottom foot  
Cabinet handle  
Filter cover  
Meaning and description of the symbols  
Contents marked with that symbol are related  
Warning sign  
to the safety of the product and the personal  
safety of the users. Please operate in strict  
conformity to the contents, otherwise it may  
cause damage of the machine or injure the  
personal safety of the user.  
Forbidding sign  
Contents marked with that symbol are actions  
forbidden to perform. Performing of those  
actions may result in damage of the machine  
or injure the personal safety of he user.  
Please check if the power receptacle has good earthing condition before  
using to guarantee your safety.  
1
 
Safety precautions  
When the machine is normally using,  
Please insert the power cord into special  
receptacle with rated voltage. Be sure to  
use single-phasethree pins receptacle.  
The ground terminal of the receptacle  
must be properly grounded. If possible,  
please adopt electric leakage protector.  
please put the power plug at the location  
easily to be inserted and extracted by hand.  
Be sure to pull the plug off when there's  
power failure, or the machine is being  
moved, cleaned or when it is idle.  
Earth  
If the power cord is bad, to avoid risk it is required to replace it by the  
technicians of our special shop or the customer care department.  
Keep the pin of the power plug clean.  
Do not put the machine at damp  
place like the bathroom . Never  
wash it with water. Do not place  
wet laundries on the control panel.  
Do not use water hotter than 50 C .  
In case the washing machine is installed  
on ground with carpet , do not block the  
ventilation hole with carpet.  
Do not wash water-proof laundries like  
the raincoat, bike covers etc. to avoid  
abnormal vibrations in spinning.  
Ventilation hole at  
the bottom of the  
washing machine  
Do not let the machine share one receptacle  
with other electric appliances. If the power  
plug is damaged, or the plugging into the  
receptacle is loose, do not use the plug any  
more.  
2
 
Safety precautions  
Do not stretch hands into the working Do not decompose, repair or alter the  
machine. It is dangerous even if the machine by yourself.  
rotation is slow. Take special care of  
the children.  
Do not put any hot or heavy items  
Do not wash laundries with volatile  
( such as the kettle with hot water )  
on the washing machine.  
materials (such as thinner, petrol etc.).  
etrol  
P
Thinner  
Keep the machine away from direct  
sunlight and heat source like the  
heater.  
Handicapped or children without care  
shall not use the machine.  
To protect your laundries and wash-  
ing machine, please take out all of the  
coins, buttons, sand, hairpin and  
other foreign materials before washing.  
Please check if the water faucet is open,  
and if the connection of the water inlet  
pipe is proper.  
It is suggested to use foamless washing  
powder.  
3
 
Installation and adjustment  
Please install and adjust the machine according to the requirement of the manual. It is  
very important to your security and correct operating the machine.  
Usage of the drain hose  
The drain hoseshall drain smoothly  
4.If extra drain hose is needed, please  
make separate purchase. The inner  
diameter of the extra hose shall not  
less than 26mm, and the length shall  
not exceed 1.5m.  
1.The height of the drain hose shall be  
less than 10cm, or the drainage will not  
be smooth, and cost such long time that  
the machine may stop at mid way.  
2.Do not ramp or press the drain hose.  
3.If the drain hose is too long, cut it at mid  
point. To make smooth drainage, cut the  
front end of the hose slantingly.  
If the extrahose is toolong, cut it  
either atA orat B point.  
Install the water inlet hose  
Water inlet pipe  
Please install the water inlet according to the machine .  
Water-filling entrance  
Control panel s frame (Figure 1)  
Insert the Water inlet pipe into the Water-filling  
entrance If want todemount the water inlet pipe  
pull it out  
.
Figure 1  
4
 
Preparation before washing  
Preparation before washing  
1.Connect the water inlet hose.  
2.Confirm that the washing machine is properly  
grounded . Then insert the power plug into the  
receptacle. Do not connect the ground terminal  
to the gas pipe and tap water pipe.  
3.Put down the drain hose .  
4.Slanting or uneven floor may result in  
unstable working or abnormal noise. Please  
make the machine stand horizontally.  
Pay attention to followings before washing the laundries  
The quantity of When the pulsator  
the laundries is running , the  
shall not be too buttons of the  
large. Stretch laundries may  
and loosen the cause noise. For  
laundries before the sake of  
Clear the  
the laundries pocket. Take  
Check if  
Tie the long  
strips; fasten  
the buttons;  
close zippers.  
has special  
requirement  
on washing  
out the coins,  
sand, hairpins  
etc.  
putting them in discretion, please  
the tub.  
put the laundries  
with buttons into  
other laundries.  
a. Check if the laundries are applicable for washing with machine.  
b. Divide the laundries that are not colorfast from other laundries.  
c. Put those laundries difficult to absorb water into water with hand.  
d. For those laundries with heavy soil, please first remove the dirt like  
mud or dust. For the parts with heavy soil, please apply detergent on  
them in advance, which can make it easier to remove the soil.  
e. For those laundries that may get lint ball and those with long fur, turn  
it over before putting in.  
f. Do not put those laundries polluted by chemicals into the washing  
machine directly.  
5
 
Operating instructions  
The capacity of washing and spinning of the machine refer  
to the largest weight of the standard laundries under dry  
condition that can be washed or spinned in one time.  
The thickness, size, type of the cloth will influence the actual  
washing capacity. It is suitable to put in reasonable amount of  
laundries and the laundries can be turned round in washing  
for one time washing.  
Do not select high water level for laundries less than 1.0kg,  
so as to avoid splashing of water.  
Usage of the detergent  
How to use the washing powder  
How to use the whitener  
Direct dissolved in the machine:  
1.Fill small quantity of water.  
2.Add the powder . Run for 30  
seconds to dissolve it completely.  
3.Put it in the laundries. Select suitable  
water level.  
The instant dissolving of the washing  
powder:  
1.Prepare warm water of 30 C and a  
container.  
Fill water to decided level. Dilute  
the whitener with container. Pour  
it slowly into the washing tub.  
Avoid using whitener on laun-  
dries with color or pattern as they  
are prone to lose color.  
The whitener shall not touch  
the laundries directly.  
2.Add the powder while stirring to fully  
dissolve it.  
Refer to the user's manual for  
the usage and quantity of the  
whitener.  
The powder is more prone to pollute the  
laundries than the detergent. Therefore  
please use it with proper quantity.  
Dosage of different washing powder is  
different. Please refer to the instruction  
of the washing powder for the detail  
dosage.  
For powder whitener, please  
dissolve it before using.  
Washing sequence  
Wash timer  
Spin timer  
(To set to below 1 minute,  
first set to 2 minute then  
turn it back. it can increase  
(To set to below 2 minute,  
first set to 6 minute then  
turn it back. it can increase  
the service life of the timer).  
WASH SELECTOR  
Water inlet  
the service life of the timer).  
OFF  
WASH  
OFF  
SPIN TIMER  
WASH TIMER  
CYCLE SELECTOR  
SPIN TIMER  
WATER INLET  
WASH TIMER  
6
 
Washing sequence  
The input water level should  
not exceed the labled position.  
Wash  
1.Fill the water  
Set the water-filling selector at the "WASH" side.  
Set the water level adjusting lever to needed line.  
Please note that the input water voltage should be  
controled between 0.02~0.2MPa.  
Figure 1  
2. Fill the water and add the dissolved washing  
powder to make the water level reach the preset  
position. Run washing program for some time to stir and  
dissolve the powder completely.(Figure 1)  
WASH  
W
ASH TIMER  
3.Put in the laundries. If the water quantity is  
insufficient, please add water.  
CYCLE SELECTOR  
WASH TIMER  
WASH  
4.Select the current.  
CYCLE SELECTOR  
Select the strength of the current according to  
the laundries. Select the washing time according to the  
laundries. (Figure 2)(Figure 3)  
Figure 3  
CYCLE SELECTOR  
Figure 2  
5.After washing, set the "WASH SELECTOR"  
at "SPIN". (Figure 4).  
CYCLE SELECTOR  
Figure 4  
Push  
Gland  
Midway spinning  
1.Put the laundries into the spin tub  
evenly and smoothly.  
Push  
2.Spin  
(1) Put the gland in properly.  
Please put in the gland properly even  
if the laundries quantity is small.  
(2) Close the inner and outer cover of the  
spin tub.  
The laundries  
are slanting  
No gland  
Proper  
Proper  
Outer cover of  
The spin tub  
Inner cover of  
The spin tub  
(3) Spin for 1-2 minutes.  
3.If the water quantity filled is too large, the water  
may flow out from the wash tub side. Please  
twist the water tap to limit the water filling.  
Rinsing  
1.Put the laundries into the wash tub. Select  
suitable current according to the laundries.  
Spinning  
1.Put the laundries into the spin tub evenly and smoothly.  
2.Press the gland in the tub properly. Close the inner and  
outer cover of the spin tub.  
2.Fill the water  
Fill suitable water continuously according to  
the laundries quantity.  
3.Spin  
Select suitable spin time according to the laundries and  
do spinning. During spinning, if there is abnormal sound  
it is generally owning to slanting placement of the laundries.  
Please stop the machine and reorder the laundries.  
3. Rinse  
Adjust the wash timer to 5-7 minutes to do  
rinsing.  
4.In spinning it will pause the work if you open the outer  
cover of the spin tub. Close it to resume the spinning.  
7
 
Maintenance and cleaning  
Please first pull off the power plug from the receptacle before cleaning.  
After washing, dismount the water inlet hose.  
Wipe the complete unit with soft  
cloth twisted dry.  
Do not store water in the tub for long period.  
Wipe with neutral detergent if  
too dirty.  
Do not wash it directly by water.  
Discharge the water immediately after each using.  
Pull off the power plug and hang up the power  
cord, Hang up the drain hose.  
Wipe off the water drops on the surface and inside  
Petrol  
Thinner  
Alcohol  
the tub with clean soft cloth. Open the cover of the  
wash tub and the inner/outer cover of the spin tub  
for some time (about one hour), then close them.  
Trouble-shooting  
When the remained water is frozen  
Prevent the freezing (be sure to discharge the water  
completely after using)  
After complete draining, set the "WASH SELECTOR"  
at "STRONG" or "STANDARD". If it is set at "DRAIN",  
it will be rather difficult for the frozen water to melt.  
Below 50  
2~3L  
When the water is frozen  
Pour hot water below 50  
into the wash tub  
to soak it completely. Then turn the pulsator  
with hands gently. Please confirm the drainage  
can work normally before next using.  
8
 
Trouble-shooting  
If there's breakdown, please pull off the power plug before checking  
Problem  
Possible reason  
Is there power failure?  
Is the power plug loose?  
Is the pulsator twisted by foreign materials?  
The machine does  
not act.  
Is the drain hose frozen?  
The draining does not  
work  
Is the drain hose blocked by foreign material?  
Are there laundries falling to the outer side of  
the spin tub?  
There's abnormal  
sound during washing  
Are there hair pin, coins or metal items brought  
inside the tub?  
Is the machine slanting?  
There's abnormal  
sound and violent  
vibration during  
spinning  
Is the gland pressed evenly?  
Are there laundries falling to the outer side of  
the spin tub?  
Are the laundries in spin tub too much?  
There may be some  
water flowing out of  
the drain hose in the  
first use of the  
It is the water remained in the factory inspection  
of performance.  
machine.  
9
 
Packing list  
Quantity  
One piece  
Name  
User's manual  
One piece  
One piece  
Warranty card  
Water inlet hose  
One piece  
One set  
Gland  
Twin-tub washing machine  
Specification  
Water level  
L
Maximum/17  
Injection pressure(MPa)  
0.02 0.2  
 

Grizzly Outdoor Cart H0759 User Manual
Hans Grohe Plumbing Product 92646000 User Manual
Harman Stove Company Stove XXV User Manual
Healthrider Treadmill HRTL12910 User Manual
Honeywell Air Cleaner F111 User Manual
Hotpoint Oven SY86P User Manual
HP Hewlett Packard Network Card 5992 4755 User Manual
HP Hewlett Packard Printer 200T User Manual
IBM Tablet Accessory DS3200 Storage Subsystem User Manual
Impex Fitness Equipment PM 50 User Manual